Blodgett HV-50 - Manual (Page 11)

9
Installation
Electrical Connections
All Models
NOTE: Electrical connections must be performed by a
qualified installer only.
Before making any electrical connections to these appli-
ances, check that the power supply is adequate for the
voltage, amperage, and phase requirements stated on
the rating name plate mounted on the appliance.
The circuit breaker that is used to provide power to this
appliance must have a minimum of .076” (3mm) contact
spacing. The circuit breaker must meet all Local and Na-
tional installation standards.
All appliances must be installed in accordance with Local
or National Electrical codes.
A wiring schematic is located on the inside of the remove-
able side panel.
NOTE: Disconnect the power supply to the appliance be-
fore servicing.
WARNING!!
Improper installation may invalidate your war-
ranty.
A strain relief for the power supply cord is provided. The
installer must supply a cord that meets all Local and Na-
tional installation standards.
WARNING!!
If the supply cord is damaged, it must be re-
placed by a special cord or assembly available
from the manufacturer or its service agent.