Allied Telesis AT-8116 - Manual (Page 80)

Software Downloading
A-2
5. Select/Create a directory into which to copy the software file, and
enter this directory.
6. Copy the software file into a file with a suitable name.
7. Set the remote software file using the set-sw-file command.
8. Operate TFTP server on the remote system host and use the sw-
dnld command on the AT-8116 to start download.
8118 TFTP Server Download Procedure
1. Insure that an IP Address is assigned.
2. Set the TFTP mode to the server using the set-tftp-mode
command.
3. Set the remote software file using the set-sw-file command.
4. Insure that the host system for the TFTP client (if AT-8116 is the
TFTP sever, then the host system should be an TFTP client) and AT-
8116 are interconnected.
5. Insert the diskette with the software file into the host drive of the
TFTP client.
6. Select/Create a directory into which to copy the software file, and
enter this directory.
7. Copy the software file into a file with a suitable name.
8. Set the remote software file using the set-sw-file command.
9. Use the sw-dnld command to start download.
10. Operate the remote TFTP client.
11. Select binary transfer mode if the code is in ASCII (equivalent to
octet in UNIX code).
12. Using the TFTP protocol, send the file (to be loaded into Flash
memory) to the IP address of the AT-8116.