Init-nvram, Get-sw-file, Set-sw-file – Allied Telesis AT-8116 User Manual

Page 24: Get-tftp-srvr, Set-tftp-srvr, Set-tftp-mode, Get-tftp-mode

System Commands

4-4

init-nvram

This command resets the non-volatile RAM (NVRAM) on the SNMP
Agent to default values. Change will take effect after boot (warm or
cold reset).

get-sw-file

This command retrieves the SNMP Agent Software file name.

set-sw-file

set-sw-file

Sets the name of the file downloaded by TFTP. This name must match
the name of the agent software file on the TFTP server.

get-tftp-srvr

This command retrieves the IP address of the TFTP server which the
Agent will use to download software (see sw-dnld).

set-tftp-srvr

set-tftp-srvr < IP address>

Sets the IP address of the TFTP server used for downloading.

set-tftp-mode

This command sets the TFTP download mode.

SYS_console> set-tftp-mode {client|server}

Switch Tftp client/server is enabled for next
download.

Refer to Appendix A, Software Downloading for more details.

get-tftp-mode

This command retrieves the TFTP download mode and requires no
argument.