Allied Telesis AT-8116 - Manual (Page 19)

AT-8116 User’s Guide
3-3
set-attr-prompt
This command sets the prompt attributes.
SYS_console>set-attr-prompt option>
[arg #0] options: 0-normal,1-bold,2-
underline,4-blink,8-reverse
SYS_console>
set-attr-msg
This command sets the display message attributes.
SYS_console>set-attr-msg
[arg #0] options: 0-normal,1-bold,2-
underline,4-blink,8-reverse
SYS_console>
set-attr-text
This command sets the text display attributes.
SYS_console>set-attr-text
[arg #0] options: 0-normal,1-bold,2-
underline,4-blink,8-reverse
SYS_console>
set-passwd
A password is not required to access the system software. However, a
username is required to log in to the system. A user simply enters his/
her username when the username prompt appears and if you do not
wish to set a password at this time, you only need to press the
or key twice to access the system’s software.
The set-passwd command allows a user to set a password or to
change the original one, if previously installed. The system first
prompts the user for the original (old) password. Then the system
prompts you for a new password. Then, type the same password
again for verification. At no time are any of the passwords echoed
back to the user.