Allied Telesis AT-8116 - Manual (Page 49)

10-1
Chapter 10
Virtual LAN Commands
Virtual LANs can be used to limit the broadcast domain and to
establish secure virtual workgroups. The following parameters are
used within the VLAN commands.
❑ run indicates that only the currently running configuration is
changed. Changes are not restored after a reset.
❑ NVRAM indicates that only the configuration stored in non-
volatile memory is changed. Changes will not take effect until
a warm or cold reset.
❑ all indicates that both the currently running configuration and
the non-volatile configuration is changed. Changes will take
effect immediately and will be restored after a reset.
Type to view the related commands.
SYS_console>vlan
get-con matrix retrieves the VLAN connectivity matrix
set-vbc domain defines a Virtual Broadcast Domain
del-vbc domain deletes a Virtual Broadcast Domain
get-vbc-tbl displays the Virtual Broadcast Domain Table
get-vbc matrix retrieves the VBC connectivity matrix
set-sec-vlan defines a Security Virtual LAN
del-sec-vlan deletes a Security Virtual LAN
get-svlan-tbl displays the Security Virtual LAN Table
get-svlan-matrix matrix retrieves the Security VLANs connectivity matrix