Allied Telesis AT-8116 - Manual (Page 59)

11-1
Chapter 11
Port Monitoring Commands
set-mon-port
This command sets the monitoring port (port containing the
monitoring device, sniffer port). All traffic from the port specified by
the monitor command will be duplicated on assigned ports. Port is a
decimal number.
set-mon-port
monitor
This command sets the port to be monitored and starts the
monitoring process. All traffic from this port will be duplicated on the
monitoring port specified by the set-mon-port command. The
monitoring device or sniffer must be connected to the monitoring
port before monitoring is activated.
monitor
stop-mon
This command ends port monitoring.
get-nv-mon
This command retrieves the port monitoring information stored by
the save-mon command in the NVRAM.