Allied Telesis AT-8550 - Manual (Page 5)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Command Guide
3
Network Management and SNMP Commands
Command Description
clear session Terminates a Telnet session from the switch.
config snmp add {} Adds the IP address of an SNMP management station to the access
list. Up to 32 addresses can be specified.
config snmp add trapreceiver
community Adds the IP address of a specified trap receiver. The IP address can
be a unicast, multicast, or broadcast. A maximum of six trap
receivers is allowed.
config snmp community [readonly |
readwrite] Adds an SNMP read or read/write community string. The default
readonly community string is public . The default readwrite
community string is private . Each community string can have a
maximum of 126 characters, and can be enclosed by double
quotation marks.
config snmp delete [ {} |
all] Deletes the IP address of a specified SNMP management station or
all SNMP management stations. If you delete all addresses, any
machine can have SNMP management access to the switch.
config snmp delete trapreceiver
[ community | all] Deletes the IP address of a specified trap receiver or all authorized
trap receivers.
config snmp syscontact Configures the name of the system contact. A maximum of 255
characters is allowed.
config snmp syslocation Configures the location of the switch. A maximum of 255 characters
is allowed.
config snmp sysname Configures the name of the switch. A maximum of 32 characters is
allowed. The default sysname is the model name of the device (for
example,
9108) . The sysname appears in the switch prompt.
disable idletimeout Disables the timer that disconnects all sessions. Once disabled,
console sessions remain open until the switch is rebooted or you
logoff. Telnet sessions remain open until you close the Telnet client.
disable rmon Disables the collection of RMON statistics on the switch.
disable snmp access Disables SNMP on the switch. Disabling SNMP access does not affect
the SNMP configuration (for example, community strings).
disable snmp traps Prevents SNMP traps from being sent from the switch. Does not
clear the SNMP trap receivers that have been configured.
disable telnet Disables Telnet access to the switch.
disable web Disables Web access to the switch.
enable idletimeout Enables a timer that disconnects all sessions (both Telnet and
console) after 20 minutes of inactivity. The default setting is
disabled.
enable rmon Enables the collection of RMON statistics on the switch.
enable snmp access Turns on SNMP support for the switch.
enable snmp traps Turns on SNMP trap support.
enable telnet Enables Telnet access to the switch.
enable web Enables Web access to the switch.
logout | quit Logs out of a console or Telnet session.