Allied Telesis AT-8550 - Manual (Page 4)

General Switch Commands
2
enable pace Enables recognition of the PACE bit. Available only in ingress mode.
help Displays a command summary list.
history Displays the previous 49 commands entered on the switch.
ping {continuous} {size } [ |
] Sends ICMP echo messages to a remote IP device. Specify:
❑ continuous — ICMP echo messages should be sent
continuously.
❑ size — The size of the packet.
❑ ipaddress — Specifies the IP address of the host.
❑ hostname — Specifies the name of the host. To use the
hostname , you must first configure DNS.
reboot { | cancel} Reboots the switch at the date and time specified. If you do not
specify a reboot time, the reboot happens immediately following
the command, and any previously scheduled reboots are cancelled.
To cancel a previously scheduled reboot, use the
cancel option.
show accounts Displays the account names, access level, number of successful and
failed login attempts, and the number of active sessions in the user
database.
show banner Displays the user-configured banner.
show diag Displays software diagnostics.
show memory Displays the current system memory information.
show switch Displays the current switch information.
show version Displays the hardware and software versions currently running on
the switch.
telnet [ | ]
{} Creates a Telnet session from the current CLI session to another host.
If the TCP port number is not specified, port 23 is used. Only VT100
emulation is supported.
traceroute Traces the routed path between the switch and a destination
endstation.
unconfig switch {all} Resets all switch parameters (with the exception of defined user
accounts) to the factory defaults. If you specify the keyword
all , the
user account information is reset as well.
Command Description