Allied Telesis AT-8550 - Manual (Page 21)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Command Guide
19
IP Route Commands
Command Description
config iproute add
Adds a static address to the routing table. Use a value of
255.255.255.255 for
mask to indicate a host entry
config iproute add blackhole
Adds a blackhole address to the routing table. All traffic destined
for the configured IP address is dropped, and no Internet Control
Message Protocol (ICMP) message is generated.
config iproute add default
{} Adds a default gateway to the routing table. A default gateway must
be located on a configured IP interface. If no metric is specified, the
default metric of 1 is used.
config iproute delete
Deletes a static address from the routing table.
config iproute delete blackhole
Deletes a blackhole address from the routing table.
config iproute delete default Deletes a default gateway from the routing table.
config iproute priority [rip | bootp | icmp |
static | ospf-intra | ospf-inter | ospf-as-external
| ospf-extern1 | ospf-extern2 ] Changes the priority for all routes from a particular route origin.
disable iproute sharing Disables load sharing for multiple routes.
enable iproute sharing Enables load sharing if multiple routes to the same destination are
available. Only paths with the same lowest cost are shared. The
default setting is enabled.
show ipqos {
} Displays the IP QoS table.
show iproute {priority | vlan |
permanent | } Displays the contents of the IP routing table.