Allied Telesis AT-8550 - Manual (Page 19)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Command Guide
17
BootP, DHCP Proxy, and UDP Profile Commands
Command Description
config bootprelay add Adds the IP destination address to forward BOOTP packets.
config bootprelay delete [ | all] Removes one or all IP destination addresses for forwarding BOOTP
packets.
config udp-profile add
[vlan | ipaddress
] Adds a forwarding entry to the specified UDP-forwarding profile
name. All broadcast packets sent to
are forwarded to
either the destination IP address (unicast or subnet directed
broadcast) or to the specified VLAN as an all-ones broadcast.
config udp-profile delete
[vlan | ipaddress
] Deletes a forwarding entry from the specified udp-profile name.
config vlan udp-profile
Assigns a UDP-forwarding profile to the source VLAN. Once the UDP
profile is associated with the VLAN, the switch picks up any
broadcast UDP packets that matches with the user configured UDP
port number, and forwards those packets to the user-defined
destination. If the UDP port is the DHCP/BOOTP port number,
appropriate DHCP/BOOTP proxy functions are invoked.
create udp-profile Creates a UDP-forwarding profile. You must use a unique name for
the UDP-forwarding profile.
delete udp-profile Deletes a UDP-forwarding profile.
disable bootprelay Disables the forwarding of BOOTP requests.
enable bootprelay Enables the forwarding of BOOTP and Dynamic Host Configuration
Protocol (DHCP) requests.
show udp-profile {} Displays the profile names, input rules of UDP port, destination IP
address, or VLAN and the source VLANs to which the profile is
applied.
unconfig udp-profile vlan [ | all] Removes the UDP-forwarding profile configuration for one or all
VLANs.