Allied Telesis AT-8550 - Manual (Page 15)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Command Guide
13
QoS Commands
Command Description
config ipqos [add | delete]
/ [qosprofile
| blackhole] Adds or deletes a QoS profile (short form).
config ipqos [add | delete] [tcp | udp | other |
all] / {l4-
dstport }
{/} {l4-
srcport } [qosprofile
| blackhole] Adds or deletes a QoS profile (long form).
config qosmode [ingress | egress] Changes the QoS mode to ingress mode or egress mode.
config qosprofile {minbw
} {maxbw } {priority
} Configures a QoS profile. Specify:
❑ minbw — The minimum bandwidth percentage guaranteed
to be available to this queue. The default setting is 0.
❑ maxbw — The maximum bandwidth percentage this queue is
permitted to use. The default setting is 100.
❑ priority — The service priority for this queue. Settings
include low, normal, medium, and high. The default setting is
low. Available only in egress mode.
create qosprofile Creates a QoS profile. The default values assigned to a created QoS
profile are
❑ Minimum bandwidth — 0%
❑ Maximum bandwidth — 100%
❑ Priority — low
delete qosprofile Deletes a QoS profile.
disable isq vlan Disables ISQ on a VLAN.
disable qosmonitor Disables the QoS monitoring capability.
enable isq vlan Enables ISQ on a per-VLAn basis. If the FDB aging timer is shorter
than 3,000 seconds, this command automatically changes the FDB
aging timer to 3,000 seconds.
enable qosmonitor {port } Enables the QoS monitoring capability on the switch. When no port is
specified, the QoS monitor automatically samples all the ports. Error
messages are logged to the syslog if the traffic exceeds the
parameters of the QoS profile(s). The default setting is disabled.
show qosprofile {} Displays QoS profile information.