Allied Telesis AT-8550 - Manual (Page 26)

IP OSPF Commands
24
config ospf spf-hold-time {} Configures the minimum number of seconds between Shortest Path
First (SPF) recalculations. The default setting is 3 seconds.
config ospf spf-hold-time {} Configures the minimum number of seconds between Shortest Path
First recalculations. The default setting is 3 seconds.
config ospf [vlan | area |
virtual-link ] timer
Configures the timers for one interface or all interfaces in the same
OSPF area. The following default, minimum, and maximum values
(in seconds) are used:
❑ retransmission_interval
Default: 5
Minimum: 0
Maximum: 3,600
❑ transmission_delay
Default: 1
Minimum: 0
Maximum: 3,600
❑ hello _interval
Default: 10
Minimum: 1
Maximum: 65,535
❑ dead_interval
Default: 40
Minimum: 1
Maximum: 2,147,483,647
config ospf [vlan | area |
virtual-link ] timer
Configures the timers for one interface or all interfaces in the same
OSPF area. The following default, minimum, and maximum values
(in seconds) are used:
❑ retransmission_interval
Default: 5
Minimum: 0
Maximum: 3600
❑ transmission_delay
Default: 1
Minimum: 0
Maximum: 3600
❑ hello _interval
Default: 10
Minimum: 1
Maximum: 65535
❑ dead_interval
Default: 40
Minimum: 1
Maximum: 2147483647
config ospf vlan area Associates a VLAN (router interface) with an OSPF area. All router
interfaces must have an associated OSPF area. By default, all router
interfaces are associated with area 0.0.0.0.
create ospf area Creates an OSPF area. Area 0.0.0.0 does not need to be created. It
exists by default.
Command Description