Allied Telesis AT-8550 - Manual (Page 24)

IP RIP Commands
22
show rip stat {vlan } Displays RIP-specific statistics for one or all VLANs.
unconfig rip {vlan } Resets all RIP parameters to match the default VLAN. Does not
change the enable/disable state of the RIP settings. If no VLAN is
specified, all VLANs are reset.
enable rip aggregation Enables RIP aggregation of subnet information an interface
configured to sent RIP v2 or RIP v2-compatible traffic.The following
rules apply when using RIP aggregation:
❑ Subnet routes are aggregated to the nearest class network
route when crossing a class boundary.
❑ Within a class boundary, no routes are aggregated.
❑ If aggregation is enabled, the behavior is the same as in RIP v1.
❑ If aggregation is disabled, subnet routes are never
aggregated, even when crossing a class boundary.
The default setting is disabled.
enable rip export static Enables the advertisement of static routes using RIP. The default
setting is disabled.
enable rip poisonreverse Enables the split horizon with poison-reverse algorithm for RIP. The
default setting is enabled. If you enable poison reverse and split
horizon, poison reverse takes precedence.
enable rip splithorizon Enables the split horizon algorithm for RIP. Default setting is
enabled.
enable rip triggerupdate Enables triggered updates. Triggered updates are a mechanism for
immediately notifying a router’s neighbors when the router adds or
deletes routes, or changes the metric of a route. The default setting
is enabled.
show rip {vlan } Displays RIP configuration and statistics for one or all VLANs.
Command Description