Allied Telesis AT-8550 - Manual (Page 33)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Command Guide
31
IPX/RIP Commands
Command Description
config ipxrip add vlan [ | all} Configures one or all IPX VLANs to run IPX/RIP. IPX/RIP is enabled by
default when you configure the IPX VLAN.
config ipxrip delete vlan [ | all] Disables IPX/RIP on one or all interfaces.
config ipxrip {vlan | all} max-packet-
size Configures the maximum transmission unit (MTU) size of the IPX/RIP
packet. the default setting is 432 bytes.
config ipxrip vlan [ | all] update-
interval {hold-multiplier } Configures the update interval and hold multiplier for IPX/RIP
updates. This setting affects both the periodic update interval of
IPX/RIP and the aging interval of learned routes. The default update
interval is 60 seconds. The aging period is calculated using the
formula (update-interval * multiplier). The default multiplier is 3.
config ipxrip vlan [ | all] delay Configures the time between each IPX/RIP packet within an update
interval. The default setting is 55 milliseconds.
disable ipxrip Disables IPX/RIP on the router.
enable ipxrip Enables IPX/RIP on the router.
show ipxrip {vlan } Displays IPX/RIP configuration and statistics for one or all VLANs.
unconfig ipxrip {vlan } Resets the IPX/RIP settings on one or all VLANs to the default.
Removes import and export filters, and resets the MTU size, update
interval, and inter-packet delay.