Allied Telesis AT-8550 - Manual (Page 34)

IPX/SAP Commands
32
IPX/SAP Commands
Command Description
config ipxsap add vlan [ | all] Configures an IPX VLAN to run IPX/SAP routing. If no VLAN is
specified, all VLANs are configured to run IPX/SAP routing. IPX/SAP
routing is enabled by default when the IPX VLAN is configured.
config ipxsap delete vlan [ | all] Disables IPX/SAP on an interface.
config ipxsap vlan [ | all] delay
Configures the time between each SAP packet within an update
interval. The default setting is 55 milliseconds.
config ipxsap vlan gns-delay Configures the amount of time the switch waits before answering a
GNS request. By default, the switch answers a GNS request as soon
as possible (0 milliseconds).
config ipxsap vlan [ | all] max-packet-
size Configures the MTU size of the IPX/SAp packets. The default setting
is 432 bytes.
config ipxsap vlan [ | all] update-
interval {hold-multiplier } Configures the update interval and hold multiplier for IPX/SAP
updates. This setting affects both the periodic update interval of SAP
and the aging interval of learned routes. The default update interval
is 60 seconds. The aging period is calculated using the formula
(update-interval * multiplier). The default multiplier is 3. Triggered
update is always enabled; therefore, new information is processed
and propagated immediately.
disable ipxsap Disables IPX/SAP on the router.
disable ipxsap gns-reply {vlan } Disables GNS reply on one or all IPX interfaces.
enable ipxsap Enables IPX/SAP on the router.
enable ipxsap gns-reply {vlan } Enables GNS reply on one or all IPX interfaces. If no VLAN is specified,
GNS reply is enabled on all IPX interfaces. The default setting is
enabled.
show ipxsap {vlan Displays IPX/SAP configuration and status for one or all VLANs.
unconfig ipxsap {vlan } Resets the IPX/SAP settings on one or all VLANs to the default.
Removes import and export filters, and resets the MTU size, update
interval, and inter-packet delay.