beautypg.com

Port commands – Allied Telesis AT-8550 User Manual

Page 10

background image

Port Commands

8

Port Commands

Command

Description

config mirroring add [mac |
vlan | port | vlan port
]

Adds a single mirroring filter definition. Up to eight mirroring
definitions can be added. You can mirror traffic from a MAC address,
a VLAN, a physical port, or a specific VLAN/port combination.

config mirroring delete [mac |
vlan | port | vlan port
| all}

Deletes a particular mirroring filter definition, or all mirroring filter
definitions.

config ports auto off {speed [10 |
100]} duplex [half | full]

Changes the configuration of a group of ports. Specify the following:

auto off

— The port will not autonegotiate the settings.

speed

— The speed of the port (for 10/100 Mbps ports only).

duplex

— The duplex setting (half- or full-duplex).

config ports auto on

Enables autonegotiation for the particular port type; 802.3u for
10/100 Mbps ports or 802.3z for Gigabit Ethernet ports.

config ports qosprofile Configures one or more ports to use a particular QoS profile.

disable learning port

Disables MAC address learning on one or more ports for security
purposes. If MAC address learning is disabled, only broadcast traffic,
EDP traffic, and packets destined to a permanent MAC address
matching that port number, are forwarded. The default setting is
enabled.

disable mirroring

Disables port-mirroring.

disable port

Disables a port. Even when disabled, the link is available for
diagnostic purposes.

disable sharing

Disables a load-sharing group of ports.

disable smartredundancy

Disables the smart redundancy feature. If the feature is disabled, the
switch changes the active link only when the current active link
becomes inoperable.

enable learning port

Enables MAC address learning on one or more ports. The default
setting is enabled.

enable mirroring to

Dedicates a port to be the mirror output port.

enable port

Enables a port.

enable sharing grouping

Defines a load-sharing group of ports. The ports specified in
<

portlist

> are grouped to the master port.

enable smartredundancy

Enables the smart redundancy feature on the redundant Gigabit
Ethernet port. When the Smart Redundancy feature is enabled, the
switch always uses the primary link when the primary link is
available. The default setting is enabled.

restart port

Resets autonegotiation for one or more ports by resetting the
physical link.

show mirroring

Displays the port-mirroring configuration.

show ports {} collisions

Displays real-time collision statistics.

show ports {} configuration

Displays the port configuration.

show ports {} info

Displays detailed system-related information

show ports {} packet

Displays a histogram of packet statistics.

This manual is related to the following products: