Allied Telesis AT-S63 - Manual (Page 431)

AT-S63 Management Software Command Line Interface User’s Guide
431
the network is uniquely
identified by the switch by
using the client's MAC
address. This is the default
setting.
authorised or Disables 802.1X port-based
forceauthenticate authentication and causes the
port to transition to the
authorized state without any
authentication exchange
required. The port transmits
and receives normal traffic
without 802.1X-based
authentication of the client.
The parameters are
equivalent.
unauthorised or Causes the port to remain in
forceunauthenticate the unauthorized state,
ignoring all attempts by the
client to authenticate. The
switch cannot provide
authentication services to the
client through the interface.
The parameters are
equivalent.
quietperiod Sets the number of seconds that the switch remains in
the quiet state following a failed authentication
exchange with the clien
t. The default value is 60
seconds. The range is 0 to 65,535 seconds.
txperiod Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the
client before retransmitting the request. The default
value is 30 seconds. The range is 1 to 65,535 seconds.
reauthperiod Enables periodic reauthentication of the client, which
is disabled by default. The default value is 3600
seconds. The range is 1 to 65,535 seconds.
supptimeout Sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this
parameter is 30 seconds. The range is 1 to 600
seconds.
servertimeout Sets the timer used by the switch to determine