Allied Telesis AT-S63 - Manual (Page 264)

Chapter 20: SNMPv3 Commands
264
CREATE SNMPV3 TARGETADDR
Syntax
create snmpv3 targetaddr= targetaddr params= params
ipaddress= ipaddress udpport= udpport timeout= timeout
retries= retries taglist= taglist
[storagetype=volatile|nonvolatile]
Parameters
targetaddr Specifies the name of the SNMP manager, or host,
that manages the SNMP activity on the switch, up to
32 alphanumeric characters.
params Specifies the target parameters name, up to 32
alphanumeric characters.
ipaddress Specifies the IP address of the host.
udpport Specifies the UDP port in the range of 0 to 65535.
The default UDP port is 162. This is an optional
parameter.
timeout Specifies the timeout value in milliseconds. The
range is 0 to 2,147,483,647 milliseconds, and the
default is 1500 milliseconds. This is an optional
parameter.
retries Specifies the number of times the switch resends an
inform message. The default is 3. This is an optional
parameter.
taglist Specifies a tag or list of tags, up to 256 alphanumeric
characters. Use a space to separate entries. This is an
optional parameter.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table entry to the
configuration file on the switch. This is the default.
nonvolatile Allows you to save the table entry to the
configuration file on the switch.
Description
This command creates an SNMPv3 Target Address Table entry.