Allied Telesis AT-S63 - Manual (Page 168)

Chapter 13: Event Log Commands
168
severity Saves events of a selected severity. Choices are I for
Informational, E for Error, W for Warning, D for
Debug, and ALL for All. The default is informational,
error, and warning. You can select more than one
severity at a time (for example, E,W).
overwrite Overwrites the file if it already exists. Without this
option, the command displays an error if the file
already exists.
Description
This command saves the current entries in the event log to a file in the
file system. The parameters in the command allow you to specify which
events you want saved in the log file. For an example of the log file, refer
to “SHOW LOG” on page 170.
Example
The following command saves all informational, error, and warning
messages stored in the permanent event log in a file called
“switch2.log”:
save log=permanent filename="switch2.log"
The following command saves the error messages of the VLAN module
stored in the temporary event log in a file called “sw14.log.”:
save log=temporary filename=sw14.log module=vlan severity=e
The following command saves all informational messages in a file called
“sw56.log” and overwrites the file of the same name that already exists
in the file system:
save log=permanent filename=sw56.log severity=i overwrite