Allied Telesis AT-S63 - Manual (Page 260)

Chapter 20: SNMPv3 Commands
260
CREATE SNMPV3 GROUP
Syntax
create snmpv3 group username= username
[securitymodel=v1|v2c|v3] groupname= groupnam e
[storagetype=volatile|nonvolatile]
Parameter
username Specifies a user name configured in the SNMPv3
User Table.
securitymodel Specifies the security model of the above user name.
The options are:
v1 Associates the Security Name, or User
Name, with the SNMPv1 protocol.
v2c Associates the Security Name, or User
Name, with the SNMPv2c protocol.
v3 Associates the Security Name, or User
Name, with the SNMPv3 protocol.
groupname Specifies a group name configured in the SNMPv3
Access Table with the access parameter. See
“CREATE SNMPV3 ACCESS” on page 255.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table entry to the
configuration file on the switch. This is the default.
nonvolatile Allows you to save the table entry to the
configuration file on the switch.
Description
This command creates an SNMPv3 SecurityToGroup Table entry.