Allied Telesis AT-S63 - Manual (Page 141)

AT-S63 Management Software Command Line Interface User’s Guide
141
SET SWITCH PORT MIRROR
Syntax
set switch port= port mirror=none|rx|tx|both
Parameters
port Specifies the source port of a port mirror. You can
specify more than one port. You can specify the ports
individually (for example, 5, 7, 22), as a range (for
example, 18-23), or both (for example, 1, 5, 14-22).
mirror Specifies which traffic on the source ports is to be
mirrored to the destination port. The options are:
rx Specifies ingress mirroring.
tx Specifies egress mirroring.
both Specifies both ingress and egress
mirroring.
none Removes a port as a source port.
Description
This command specifies the source ports of a port mirror. If the port
mirror already has source ports, the new source ports are added to the
existing ports. You can also use the command to remove source ports.
You must set the destination port before you can select the source ports.
To set the destination port, refer to “SET SWITCH MIRROR” on page 140.
Note
When a transceiver is inserted into an uplink slot and a link is
established, that slot becomes a primary uplink port and the
corresponding backup port, 23R or 24R, automatically transitions to
redundant uplink status. Any settings for port mirroring remain
intact when the backup port makes the transition to a redundant
uplink state.
Examples
The following command specifies ports 16 and 17 as new source ports
for the port mirror. Only the ingress traffic is mirrored:
set switch port=16-17 mirror=rx