Allied Telesis AT-S63 - Manual (Page 256)

Chapter 20: SNMPv3 Commands
256
to this parameter, then the writeview parameter
defaults to none.
notifyview Specifies a Notify View Name that allows the users
assigned to this Group Name to send traps
permitted in the specified View. This is an optional
parameter. If you do not assign a value to this
parameter, then the notifyview parameter defaults
to none.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table entry to the
configuration file on the switch. This is the default.
nonvolatile Allows you to save the table entry to the
configuration file on the switch.
Description
This command creates an SNMPv3 Access Table entry.
Examples
The following command creates a security group called
“testengineering” with a security model of SNMPv3 and a security level
of privacy. The security group has a read view named “internet,” a write
view named private, and a notify view named “internet.” The storage
type is nonvolatile storage.
create snmpv3 access=testengineering securitymodel=v3
securitylevel=privacy readview=internet writeview=private
notifyview=internet storage=nonvolatile
The following command creates a security group called “swengineering”
with a security model of SNMPv3 and a security level of authentication.
In addition, the security group has a read view named “internet,” a write
view named experimental, and a notify view named “mgmt”
(management). The storage type group is nonvolatile storage.
create snmpv3 access=swengineering securitymodel=v3
securitylevel=authentication readview=internet
writeview=experimental notifyview=mgmt storage=nonvolatile
The following command creates a security group called
“hwengineering” with a security model of SNMPv3 and a security level of
noauthentication. In addition, the security group has a read view named
“internet.”