beautypg.com

Chapter 32, Tacacs+ and radius commands, Chapter 32 tacacs+ and radius commands – Allied Telesis AT-S63 User Manual

Page 413

background image

413

Chapter 32

TACACS+ and RADIUS
Commands

This chapter contains the following commands:

❑ “ADD RADIUSSERVER” on page 414

❑ “ADD TACACSSERVER” on page 416

❑ “DELETE RADIUSSERVER” on page 417

❑ “DELETE TACACSSERVER” on page 418

❑ “DISABLE AUTHENTICATION” on page 419

❑ “ENABLE AUTHENTICATION” on page 420

❑ “PURGE AUTHENTICATION” on page 421

❑ “SET AUTHENTICATION” on page 422

❑ “SHOW AUTHENTICATION” on page 424

Note

Remember to save your changes with the SAVE CONFIGURATION
command.

Note

For background information on the RADIUS and TACACS+
protocols, refer to Chapter 30, “TACACS+ and RADIUS Protocols” in
the AT-S63 Management Software Menus Interface User’s Guide.

See also other documents in the category Allied Telesis Computer hardware: