Allied Telesis AT-S88 - Manual (Page 72)

Chapter 7: Port Mirroring
64
Modifying a Port Mirror
To modify a port mirror, perform the following procedure.
1. From the main menu, select Bridge > Mirroring.
The Mirroring page is shown in Figure 19 on page 61
2. Select or de-select the ports whose ingress traffic you want to monitor
by clicking the port icon in the graphic image of the switch front at the
top of the page.
3. Select or de-select the ports whose egress traffic you want to monitor
by clicking the port icon in the graphic image of the switch front at the
top of the page.
4. In the Monitor Port list, select the port to which the traffic will be sent,
if you want to change that.
5. In the Mirror Mode list, select Enable.
6. Do one of the following:
ˆ Click OK to save the port mirror.
ˆ Click Reload to clear the port mirror and start over.
7. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 13.
8. Click Save.