Allied Telesis AT-S88 User Manual
Page 39
AT-S88 Management Software User’s Guide
31
b. In the Control list, select Enable to enable the control, or Disable
to disable it.
c. In the Mode list, select one of the following:
All
Affects broadcast, multicast, and Dlf packets.
Bcast
Controls only broadcast packets.
Bcast, Mcast
Limits broadcast and multicast packets.
Bcast, Mcast, Dlf
Limits broadcast, multicast, and Dlf packets.
d. In the Limit rate field, enter a number for the rate limit.
The range is 70 to 250,000 packets per second.
e. Click Modify.
3. In the Egress Bandwidth Control section, do the following:
a. In the Port List, select the port you want to configure, or scroll
through the list below.
The port is highlighted in the port list.
b. In the Control list, select Enable to enable the control, or Disable
to disable it.
c. In the Limit rate field, enter a number for the rate limit.
The range is 70 to 250,000 packets per second.
d. Click Modify.
4. Do one of the following:
Click OK to save the changes.
Click Reload to clear the settings and start over.
5. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 13.
6. Click Save.