Allied Telesis AT-S88 - Manual (Page 113)

AT-S88 Management Software User’s Guide
105
Root MAC Address
The MAC address of the root bridge.
Switch MAC Address
The MAC address of the switch. This value cannot be changed.
Bridge Hello Time
The time interval between generating and sending configuration
messages by the bridge. This parameter can be from 1 to 10 seconds.
The default is 2 seconds.
Bridge Max Age
The length of time after which stored bridge protocol data units
(BPDUs) are deleted by the bridge. All bridges in a bridged LAN use
this aging time to test the age of stored configuration messages called
bridge protocol data units (BPDUs). For example, if you use the default
value 20, all bridges delete current configuration messages after 20
seconds. This parameter can be from 6 to 40 seconds.
When you select a value for maximum age, observe the following
rules:
MaxAge must be greater than (2 x (HelloTime + 1)).
MaxAge must be less than (2 x (ForwardingDelay - 1)).
Note
The aging time for BPDUs is different from the aging time used by
the MAC address table.
Bridge Forward Delay
The waiting period in seconds before a bridge changes to a new state,
for example, becomes the new root bridge after the topology changes.
If the bridge transitions too soon, not all links may have yet adapted to
the change, resulting in network loops.
Root Bridge Priority
The priority number for the bridge. This number is used to determine
the root bridge for RSTP. The bridge with the lowest priority number is
selected as the root bridge. If two or more bridges have the same
priority value, the bridge with the numerically lowest MAC address
becomes the root bridge. When a root bridge goes offline, the bridge
with the next priority number automatically takes over as the root
bridge.
2. In the Spanning Tree is list, select one of the following:
Disabled
Spanning tree is disabled. This is the default setting.