Allied Telesis AT-8000GS/48 - Manual (Page 41)

AT-8000GS Series Gigabit Ethernet Switch Installation Guide
41
The Startup Menu is displayed and contains the following configuration
functions:
6. From the Startup Menu, press “5”.
The following prompt is displayed:
7. From the Stack Menu, press “3” to set the unit working mode.
The following prompt is displayed:
8. Press “2” to select the stacking working mode and press enter.
The Stack menu (shown above) is displayed again.
9. From the Stack menu, press “2” to set the unit stack id.
The following prompt is displayed:
10. Enter the unit stack number. Note that Units 1 and 2 are master-
enabled units. One of them will be elected as Stack Master. Therefore,
at least one unit in the stack must be designated as either Unit 1 or
Unit 2.
11. Press . The device is defined within the stack.
Startup Menu
[1] Download Software
[2] Erase Flash File
[3] Enter Diagnostic Mode
[4] Set Terminal Baud-Rate
[5] Stack menu
[6] Back
Enter your choice or press 'ESC' to exit:
Stack menu
[1] Show unit stack id
[2] Set unit stack id
[3] Set unit working mode
[4] Back
Enter your choice or press 'ESC' to exit:
Enter unit working mode [1 - standalone, 2 - stacking]: 2
Unit working mode changed to stacking.
==== Press Enter To Continue ====
Enter your choice or press 'ESC' to exit:
Unit number in stack: [0-6] 1