Allied Telesis AT-8000GS/48 - Manual (Page 32)

Chapter 2: Installation
32
Installing the Device
The device can be installed on a flat surface or mounted in a rack. This
section includes the following topics:
ˆ “Desktop or Shelf Installation” on page 31
ˆ “Rack Installation” on page 31
Desktop or Shelf
Installation
When installing the switch on a desktop or shelf, the rubber feet included
with the device should first be attached. Attach these cushioning feet on
the bottom at each corner of the device.
Ensure the surface is be able to support the weight of the device and the
device cables.
To install the device on a surface, perform the following:
1. Attach the rubber feet on the bottom of the device. The following figure
illustrates the rubber feet installation on the device.
Figure 1: Installing Rubber Feet
2. Set device down on a flat surface, while leaving 2 inches on each side
and 5 inches at the back.
3. Ensure that the device has proper ventilation by allowing adequate
space for ventilation between the device and the objects around the
device.
Rack Installation
The device can be mounted in an EIA standard-sized, 19-inch rack, which
can be placed in a wiring closet with other equipment. To install the device
the mounting brackets must first be attached to the device’s sides.