Allied Telesis AT-8000GS/48 - Manual (Page 30)

Chapter 2: Installation
30
ˆ Power — The unit is installed within 1.5 m (5 feet) of a grounded,
easily accessible outlet 100-250V AC, 50-60Hz.
ˆ Clearance — There is adequate frontal clearance for operator access.
Allow clearance for cabling, power connections, and ventilation.
ˆ Cabling — The cabling is routed to avoid sources of electrical noise
such as radio transmitters, broadcast amplifiers, power lines, and
fluorescent lighting fixtures.
ˆ Ambient Requirements — The ambient unit operating temperature
range is 0 to 40ºC (32 to 104ºF) at a relative humidity of up to 95%,
non-condensing. Verify that water or moisture cannot enter the device
casing.
Unpacking
This section contains information for unpacking the device, and includes
the following topics:
ˆ “Package Contents” on page 30
ˆ “Warranty” on page 30
ˆ “Unpacking Essentials” on page 30
Package Contents
While unpacking the device, ensure that the following items are included:
ˆ One AT-8000GS series unit
ˆ Rubber Feet for desktop installation
ˆ Rack-mount kit hardware accessories
ˆ An AC power cable
ˆ Stacking cable (Yellow color)
ˆ Console RS-232 cable with RJ-45 connector
ˆ Installation guide on CD
Warranty
The AT-AT-8000 series switches have a Lifetime Warranty (two years for
Fan and PSU). Go to www.alliedtelesis.com/warranty for the specific terms
and conditions of the warranty and for warranty registration.
Unpacking Essentials
Note
Before unpacking the device, inspect the package and report any
evidence of damage immediately.
To unpack the device perform the following:
1. It is recommended to put on an ESD wrist strap and attach the ESD