Allied Telesis AT-x210-9GT - Manual (Page 17)

AT-x210-9GT, AT-x210-16GT, and AT-x210-24GT Switches Installation Guide
7
LEDs Here is a brief description of the port LEDs:
„ Power LED/Fault/Standby LEDs; refer to “POWER/FAULT/
STANDBY LEDs” on page 13.
„ Speed and link/activity LEDs for the twisted pair ports; see
“10Base-T/100Base-TX/1000 Base-T Link Activity LEDs” on
page 15.
„ Link/activity LEDs for the SFP slots; see “SFP LEDs” on page 17.
Installation
Options
The AT-x210-9GT switch can be installed in the following way:
„ Mounted on a Desk or tabletop
The AT-x210-16GT and AT-x210-24GT switches can be installed in the
following ways:
„ Rack mounted in a19-inch equipment rack
„ Mounted on a Desk or tabletop
„ Wall mounted
Power
Conservation
The AT-x210-9GT, AT-x210-16GT, and AT-x210-24GT switches have the
following power conservation features:
„ High-efficiency power supply
„ Power scaling based on traffic loads on ports operating at 1000
Mbps (Port power scaling not available at 10 or 100 Mbps)
„ Power shutdown on unused ports
MAC Address
Table
Here are the basic features of the MAC address table:
„ Storage capacity up to 8KB MAC address entries
„ Automatic learning and aging