beautypg.com

Allied Telesis x310 Series User Manual

Page 70

background image

Chapter 4: Installing the Switch on a Wall

70

5. Have another person hold the switch on the concrete wall at the

selected location for the device while you use a pencil or pen to mark
the wall with the locations of the two screw holes in the brackets. Refer
to Figure 27. Be sure that the selected location adheres to the
recommendations in “Recommended Minimum Wall Area Dimensions”
on page 66.

Figure 27. Marking the Locations of the Bracket Holes on a Concrete Wall

6. Place the switch on a table or desk.

7. Use a drill and a 1/4” carbide drill bit to pre-drill the two holes you

marked in step 5. Please review the following guidelines:

Prior to drilling, set the drill to hammer and rotation mode. The
modes break up the concrete and clean out the hole.