Allied Telesis x310 Series - Manual (Page 66)

Chapter 4: Installing the Switch on a Wall
66
Installing the AT-x310-26FT Switch on a Wall
This section contains the tools, guidelines, and procedures for installing
the AT-x310-26FT Switch on a wall.
Positions of the
Switch on a Wall
You may install the switch on the wall with the front panel on the left or
right, as shown in Figure 23. You may not install it with the front panel on
the top or bottom.
Figure 23. Positions of the AT-x310-26FT Switch on a Wall
Recommended
Minimum Wall
Area Dimensions
The wall location for the AT-x310-26FT Switch must provide adequate
space to the front and back panels so that you can service the unit, and for
ventilation. The recommended minimum dimensions for the reserved wall
area are listed here:
 Width: 54.0 centimeters (21 1/4 inches)
 Height: 43.2 centimeters (17 inches)
You should position the switch in the reserved wall area such that the front
panel has more space than the rear panel. This may make it easier for you