Allied Telesis x310 Series - Manual (Page 59)

x310 Series Installation Guide for Stand-alone Switches
59
Installing the Switch on a Table
This section contains the procedure for installing the switch on a table or
desk.
Note
The rubber feet on the bottom of the chassis should be left on for
table installation.
Warning
Do not stack switches on top of one another on a table or desktop.
That could result in a safety hazard. The switches could be
damaged or you might be injured if they tip over.
To install the chassis on a table, perform the following procedure:
1. Review “Selecting a Site for the Switch” on page 58 to verify the
suitable of the site for the switch.
2. Check to be sure that the table is strong enough to support the weight
of the switch.
3. Lift the switch onto the table.
4. Go to Chapter 5, “Cabling the Networking Ports” on page 85 to connect
the network cables.