beautypg.com

Allied Telesis x310 Series User Manual

Page 104

background image

Chapter 6: Powering On the Switch

104

Figure 58. Saving the Changes with the WRITE Command

9. Enter the REBOOT command to reboot the switch.

10. At the confirmation prompt, type “Y” for yes.

11. Wait for the switch to initialize its management software and

afterwards examine the Switch ID LED. If the ID number is “0,” the
switch is ready for normal network operations as a stand-alone unit.
Refer to the Software Reference for x310 Series Switches, AlliedWare
Plus Operating System,
for instructions on how to configure the
operating parameters. If the number is not “0,” repeat this procedure.

awplus# write
Building configuration ...
[OK]
awplus#