Allied Telesis AT-WA1004G - Manual (Page 72)

Operation and Status
72
Connection Status - PPTP
If using PPTP (Peer-to-Peer Tunneling Protocol), a screen will be
displayed when the “Connection Details” button is clicked.
Data - PPTP Screen
Connection
Physical Address The hardware address of this device, as seen by
remote devices on the Internet. (This is different to
the hardware address seen by devices on the local
LAN.)
IP Address The IP Address of this device, as seen by Internet
users. This address is allocated by your ISP (Internet
Service Provider).
PPTP Status This indicates whether or not the connection is
currently established.
❏ If the connection does not exist, the “Connect”
button can be used to establish a connection.
❏ If the connection currently exists, the
“Disconnect” button can be used to break the
connection.
Connection Log
Connection Log
❏ The Connection Log shows status messages
relating to the existing connection.
❏ The “Clear Log” button will restart the Log, while
the Refresh button will update the messages
shown on screen.
Buttons
Connect If not connected, establish a connection to your
ISP.
Disconnect If connected to your ISP, hang up the connection.
Clear Log Delete all data currently in the Log. This will make it
easier to read new messages.
Refresh Update the data on screen.