Samsung HMX-M20BN-XAA - Manual (Page 124)

120
connecting to a TV
Nornal TV
Camcorder
Component/AV cable
Signal flow
Type B: Connecting a Component/AV cable for the composite output.
Type B: Connecting a Component/AV cable for composite output
1. Connect the provided component/AV cable to the Composite jacks -“Video and L-R (Audio)”
- on your TV. Use the Green plug with the yellow label to connect to the Video input.
• After the connection is complete, set “Analog TV Out” to “Composite.” page 103
2. Turn on the TV and set TV’s the input selector to the Input connection your camcorder is
connected to.
• This is often referred to as “line.”
• Refer to the TV instruction manual for how to switch the TV input.
If the P
B
, P
R
, or Y jack is not connected correctly, the TV screen may appear red or blue.
• If you see no image or the image is distorted, check the connections between the HD camcorder
and TV. The TV can not display an image properly if the connections are incorrect.
• If you connect the camcorder to your TV using more than one connection method, the camcoorder
outputs signal in the following order of priority: HDMI Component/AV output.
• Do not use excessive force when connecting the cables.
• For more information about TV connection jacks and connecting methods, see your TV’s user’s
manual.
• On some standard definition TVs, the Composite Video input jack and the Y Component input jack
are the same jack. If you are following directions for the Type B composite connection above, and
the Video and Y jack are the same on your TV, plug the Green plug into the “Y” input jack instead
of “VIDEO.”
• When you set the camcorder output resolution to 1080/60p, the camcorder cannot output to the
camcorder's LCD screen and the connected TV simultaneously. The LCD displays “TV display only.”