Samsung SCH-R400ZPAMTR - Manual (Page 52)

52
Note: The Lookup command shows the requested contact information in the display but does not dial any
phone numbers for the contact.
To look up information for a specific contact:
1. In standby mode, press and hold the key to launch VoiceSignal.
“Say a Command” appears in the display and is pronounced through the
speaker.
2. Say “Lookup”.
VoiceSignal prompts you to “Say the name.”
3. Speak clearly and say the full name of the person you want to call, exactly
as it is entered in your Contacts list.
• If VoiceSignal recognizes the name you said, the contact information for that
name appears in the display.
• If VoiceSignal does not recognize the name you said, a choice list of up to three
names appears in the display, and VoiceSignal prompts you with “Did you
say?” followed by the first name on the list.
4. Say “Yes” to confirm the name or “No” to hear the next name, or use the
keypad to select the correct name from the list. (See See “Choice Lists” on
page 94, for more information.)
• To say the name again, press the Repeat (right) soft ( ) key.
• To exit VoiceSignal without dialing, press the Settings (left) soft ( ) key and
press the Exit (right) soft ( ).
5. The contact information for the name you selected appears in the display.
• Press to dial the number associated with the name.
• Press the Erase (left) soft key ( ) to erase this entry from your Contacts list.
• Press the EDIT key ( ) to add or change information for this entry.
• Press the Options (right) soft key ( ) and the following options popup in the
display:
– Send Txt Msg
– Send Pic Msg
– Call
Soft Key Method
If you’ve stored a name entry in Contacts, Find allows you to find it quickly.
1. In standby mode, press the Contacts (left) soft key ( ).
The Find screen appears in the display with the Go To field highlighted,
followed by the first few names in your Contacts list.
SEND
OK