Campbell Scientific PC400 Datalogger Support Software - Manual (Page 154)

Section 8. Datalogger Program Creation with Edlog
Editing functions are available from the Input Location Editor’s Edit menu and
a hot key:
Insert () – Inserts blank Input Locations. This is used to provide space for
new input labels between existing labels. This automatically changes the Input
Location numbers for all of the labels that are after the inserted location.
Delete () – Deletes the Input Location label, flags, number of reads and
writes, and block information for a designated location number. Wherever the
datalogger program references a deleted location label, the Input Location’s
number automatically becomes 0.
Move () – Moves the Input Location to a different number. This may
change several Input Location numbers.
Toggle Manual () – Allows the programmer to manually toggle a location
as “in use”. This is used for burst mode, indexed loops, or other situations
where it’s not clear to Edlog that the locations are being written to. Input
Locations not marked as read, write, or manual are deleted by the Optimize
command.
8-18