Campbell Scientific PC208 Datalogger Support Software - Manual (Page 73)

SECTION 4. SPLIT
4-19
CURSOR COMMAND N KEY(s)
Up ........................................................................ Ctrl E or Up Arrow
Down.................................................................... Ctrl X or Down Arrow
Left ....................................................................... Ctrl S or Left Arrow
Right..................................................................... Ctrl D or Right Arrow
Word Left ............................................................. Ctrl A
Word Right........................................................... Ctrl F
Page Up ............................................................... Ctrl R or PgUp
Page Down .......................................................... Ctrl C or PgDn
Home ................................................................... Beginning of parameters
End....................................................................... End of parameters
DELETE COMMANDS
Delete Character at cursor................................... Ctrl G or Delete Key
Delete Character Left........................................... Backspace Key
Delete Word To Right .......................................... Ctrl T
Delete Entry ......................................................... Ctrl Y
SPECIAL COMMANDS
Ctrl KB................................................................. Put entry from cursor to end of entry into buffer. If
entry is changed, then buffer is emptied.
Ctrl KC ................................................................ Copy contents of buffer at cursor.
Ctrl N................................................................... Enter nulls until end of the line (in effect, starts a new
line in the current entry).
F1......................................................................... Help for current entry.
F2......................................................................... Enter command mode.
{ ........................................................................... Start comment.
} ........................................................................... End comment.
INS ....................................................................... Insert off/Insert on.
4.6 COMMAND MENU
To switch to the COMMAND Menu from the
EDIT Mode press the F2 key. Select a
command by pressing the first letter of that
command or use the arrow keys to move the
cursor to the command and press return. The
user can back out of a command by pressing
the ESC key. An explanation of the available
five commands follows.
EDIT
EDIT puts SPLIT into the parameter file for
editing (Section 4.3).
RUN
RUN compiles and executes the .PAR file.
When execution is complete SPLIT returns to
the COMMAND MENU. The ESC (escape) Key
aborts execution. Control S halts execution
until another key is pressed to resume
execution.