Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 43)

Section 7. Camera Operation Using Web Browser Interface
7-7
Full Power Save
Mode
• The camera is effectively off in a low powered state.
• Average Power consumption is typically 10 mA @ 12VDC.
• The Ethernet is normally turned off and is only enabled when
outgoing communications are required (Email or FTP).
• User needs to push the Setup button to temporarily enable the
camera and Ethernet port for Web page access.
• The camera can respond to RS-232 and RS-485 communications in
this mode.
Always On
• The Deep Sleep power consumption(6mA typical) is not affected by
the Ethernet Power Mode
• Ethernet, RS-232 and RS-485 communications are non responsive
in the Deep Sleep State.
Moderate Power
Save Mode
• Not recommended
Deep Sleep
Full Power Save
Mode
• The Deep Sleep power consumption(6mA typical) is not affected by
the Ethernet Power Mode
• If Ethernet communications are not used this can reduce the power
consumption of the camera by 50 mA when the camera exits the
deep sleep state.
Always On
• The Off State power consumption(1mA typical) is not affected by
the Ethernet Power Mode
• Ethernet, RS-232 and RS-485 communications are non responsive
in the OFF State.
Moderate Power
Save Mode
• Not recommended
Off State
Full Power Save
Mode
• The Off State power consumption(1mA typical) is not affected by
the Ethernet Power Mode
• If Ethernet communications are not used this can reduce the power
consumption of the camera by 50 mA when the camera exits the
deep sleep state.
7.2.3 FTP Server Setting
Clicking on the FTP Server sub tab will display the FTP Server settings (see
FIGURE 7-7).
FIGURE 7-7. FTP Server Settings