Campbell Scientific CC5MPX and CC5MPXWD Digital Network Cameras - Manual (Page 23)

4-1
Section 4. Cables/Wiring
4.1 Power and I/O Cable Connections
The wiring for the CC5MPXCBL1-L Power and I/O Cable is as shown in
TABLE 4-1 and FIGURE 4-1 through FIGURE 4-4.
It is essential that the Ground cable be connected first when
wiring the camera to the datalogger or the power supply.
TABLE 4-1. CC5MPXCBL1-L Power and I/O Cable Color Connections
Color Function Connection
Black Power Ground System Ground
Red Input Power Power Source 9-30 VDC
Green RS-232 TX (Output) RS-232 Input (Pin 2 of a computer (DTE)
DB-9 connector or even-numbered
control port of a TX/RX pair on a CR800,
CR1000, or CR3000)
RS-485A when configured to RS-485
White RS-232 RX (Input) RS-232 Output (Pin 3 of a computer
(DTE) DB-9 connector or odd-numbered
control port of a TX/RX pair on a CR800,
CR1000, or CR3000)
RS-485B when configured to RS-485
Yellow Communication
Switched Power
(Output)
This line is intended to power a
communication device. The camera
switches the Input Power voltage to this
line.
Blue Enable Wakes up or initiates image/video
acquisition.
Clear Shield Shield/Earth Ground
Refer to Section 8 Internal Jumpers if the current RS-232 or RS-485 interface
option needs to be changed in the camera.
Refer to TABLE 4-2 to help determine which wires will need to be connected
for your camera application.
NOTE