Flytec 5030 v2.24 * - Manual (Page 9)

Flytec
5030 GPS
Modul
Modulation (see graphic below)
SinktoneF
Sink tone/alarm The basic tone deepens when sink increases.
Frequency base you can choose the pitch of the sink tone (or sink alarm) under
‘Sinkton Freq’. (factory setting = 700 Hz ) The sink tone is continuous
and decreases in frequency as the sink speed increases and
increases in frequency when approaching rising air. The descent tone
can be turned off by pressing the button /Route briefly. If you turn it
back on, you would then hear the start frequency and the analogue
vario display would show the starting point of the decent. Under
‘Basic Settings/Sink tone threshold’ you can choose the point at which
the sink tone will start. It cannot be set to a higher frequency than the
climb acoustic frequency. The basic tone acoustic may be set lower.
damp
Dampening The vario value is re-calculated every 0.2s. Rapid vario changes may
result in wide variations in tone frequency (pitch). The ear registers it
as a fast piano effect. In order to change this, a damping may be
added. Damping the rapid tone and frequency results in the vario
being more settled.
Beepch
Beepchose From Vers.2.21 on, it is possible to choose two different acoustic
settings under „Beepchoose“ in the Basic Settings. 0 is the old setting,
and 1 allows you to choose, that the acoustic increases or decreases
during a beep.
9/53