Videotec WASPT - Manual (Page 4)

EN - English - I
nstruc
tions manual
2
4 Identification
4.1 Product description and type
designation
Glass cleaning kit for ULISSE and ULISSE COMPACT
series pan & tilts and housings.
5l (1.3gal) o 23l (6gal) tank. Different pumps are
available for delivery up to 5m (16ft), 11m (36ft) or
30m (98ft). Available voltages in 230Vac, 24Vac or
120Vac. Pumps with 30m (98ft) delivery are available
only in 230Vac or 120Vac.
In the 11m (36ft) and 30m (98ft) delivery versions the
lack of liquid in the tank is signalled following the
automatic stop of the pump.
With the stand-alone housing (no P&T and no
telemetry receiver), it is possible to remotely control
via RS485 the wiper and the washer pump by using
the DTWRX optional board.
4.2 Product markings
See the label attached to the outside of the package.
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Safety precautions before use
In the 115/230Vac powered configuration
it is necessary to insert a 1 0 unipolar main
switch (open contact distance d>3mm).
This switch should be used to disconnect
the power supply before carrying out any
maintenance operation or before opening
the procuct.
5.2 Unpacking and contents
5.2.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
5.2.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Washer kit
• Ties
• Silicon sheath
• Pipe connector
• Washer pipe support
• Locking bracket for pipe support
• Delivery pipe
• Washer pipe (with nozzle)
• Bolts and screws
• Instructions manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
When returning a faulty product we recommend
using the original packaging for shipping.