CDN WT2 - Wireless Probe Thermometer/Timer EN - Manual (Page 5)

Precautions
• Always wear a heat resistant glove to touch the
stainless steel probe or sensor cable during or just
after cooking. Do not touch with bare hands.
• Keep the batteries, stainless steel probe and sensor
cable away from children.
• Clean the probe and dry thoroughly after use.
• Do not clean the case with abrasive or corrosive
compound, which may scratch the plastic and
corrode the electronic circuits.
• Do not subject the unit to excessive force shock,
dust, temperature or humidity, which may result in
malfunction, shorter electronic life span, damaged
battery and distorted parts.
• Do not tamper with the unit’s internal components.
Doing so will invalidated the warranty on the unit
and may cause unnecessary battery damage and
distorted parts.
• Do not subject the unit to excessive exposure to
direct sunlight. The unit is not waterproof — do
not immerse it into water or expose to heavy rain.
Only the probe can be submerged in liquid.
The probe/cable connection is not waterproof.
• Do not expose the sensor cable plug or the jack on
the case to water or any liquid, which will result in
a bad connection and faulty readings.
• Do not place the unit in extreme temperatures.
Never burn the probe directly over the fire. Do
not use the probe when the temperature is above
482°F/250°C. Doing so will deteriorate the interior
element. The high-heat sensor cable is safe up to
700°F/371°C.
• Do not use the probe in a microwave oven.
• Always read the user manual thoroughly before
operating.
Specifications
Temperature Alert: 32 to 212°F/0 to 1000°C
°F/°C selectable
Timer: Counts down 100 minutes by seconds;
counts up 100 minutes by seconds
Power: Base: 2 DC 1.5V size AAA
Remote: 2 DC 1.5V size AAA
CAUTION: Avoid keeping the thermometer too close to objects
that continuously generate high heat for long periods (i.e., hot
plate). This can cause the thermometer to overheat.
CE Note: This device could be sensitive to electrostatic
discharge. If electrostatic discharge or malfunctioning occurs,
please re-install the battery to reset this unit.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.