Red Lion LEGEND - Manual (Page 30)

-28-
PROGRAM OPTIONS MODULE (Cont’d)
USER SETTINGS
This module should only be entered if the operator wants to reset ALL
parameters to the factory settings. When the word “FACTORY” is flashing in
the display and the ENT key is pressed, all parameters will be set to the factory
settings when exiting the programming loop.The operator can exit the factory
settings option WITHOUT resetting all parameters by pressing the key. The following are the settings when shipped from the factory, along with
a chart for user settings:
CAUTION: If factory settings are selected, all programming by the user will be
reset.
LGM FACTORY SETTINGS
PRESETS:
P1 500
P2 1000
P3 300
P4 400
P5 500
P6 600
Counter Load 100
COUNT:
Scale Factor 1.0000
SCM X1
Decimal Point 0
Input CT+DIRX1
Reset to ZERO
Auto Reset DISABLED
RATE:
Scale Factor 1.0000
SCM X1
Decimal Point 0
Rate Per SECOND
Min. Time 1.0
Max. Time 5.0
USER INPUTS:
User Input 1 NO MODE
User Input 2 NO MODE
User Input 3 NO MODE
User Key F1 MAINTAIN RESET
RATE NO
PEAK YES
VALLEY YES
COUNT NO
User Key F2 MAINTAIN RESET
RATE NO
PEAK NO
VALLEY NO
COUNT YES
OUTPUTS:
Output 1:
Assigned TO COUNT
Phase + PHASE
Type TIMED
Time Delay 0.1
OUT1 END DISABLED
Status [email protected]
Reset w/Cnt ENABLED
Output 2:
Assigned TO COUNT
Phase + PHASE
Type TIMED
Time Delay 0.1
OUT2 END DISABLED
Status [email protected]
Reset w/Cnt ENABLED
Output 3:
Assigned TO COUNT
Phase + PHASE
Type TIMED
Time Delay 0.1
Status [email protected]
Reset w/Cnt ENABLED