Vaisala MMT330 - Manual (Page 47)

Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 47
Sampling Cell for MMT338
It may be necessary to use a sampling cell if the MMT338 probe cannot
be installed directly into the process pipe, for example, if the pipe is too
small for the probe. Then, a by-pass sampling line may be feasible.
Sampling Cell with Swagelok Connectors (Vaisala order code:
DMT242SC2) is available as an optional accessory.
0511-108
Figure 27 Sampling Cell DMT242SC2
The following numbers refer to Figure 27 above:
1 = Male pipe weld connector Swagelok 1/4"
2 = G1/2"