DAVIS DriveRight 600E GD/HD Installation Guide (8126GD, 8126HD) - Manual (Page 7)

Often you can route the sensor wires through an existing feedthrough in the
firewall.
❏ Decide where to install the harness cable and where to connect the power
and ground leads. (Procedure 2)
Find a location inside the vehicle where you can bring together the harness
cable leads, the power and ground tap wires, the adapter cable leads, and
the sensor cable leads. The location should allow the adapter cable to reach
the DriveRight console.
❏ Determine where to connect the digital input leads (if used). Digital input 1 is
typically used to monitor brake lights and digital input 2 is used to monitor
headlights. (Procedure 3)
:LULQJ 'LDJUDP
Display
Harness Cable
Adapter Cable
Butt
Splices
(2)
Blue Wires
with
In-Line
Fuses
Green
Yellow
Red
Black Ground
Digital
Inputs
1
2
White
Black
Red
Butt Splices (3) Red Wire with
Fuseholder
In-Line
Splice
In-Line
Splice
Red
Unswitched
+12V
Ground
Spade Terminal
Vehicle Drive Shaft
or CV Joint Hub
Sensor Magnet Assembly
Sensor Support
Bracket
Typical DriveRight Installation
07395.043 DR GD Inst Rev D Body D146.fm Page 5 Monday, December 1, 2003 12:02 PM