DAVIS DriveRight 600E GD/HD Installation Guide (8126GD, 8126HD) - Manual (Page 17)

3URFHGXUH )LQLVK WKH ,QVWDOODWLRQ
Use the following steps to finish the installation.
& $87,21 It is not necessary to enter a code in order to perform this test. DO NOT ENTER A
CODE UNTIL YOU READ THE USER’S MANUAL.
,QVWDOO WKH %DWWHU\
Insert the battery into the DriveRight console as shown below.
The screen you should see is the current readings screen. The word “BAT”
should appear in the lower left corner, indicating that the unit is operating on
battery power.
! Press and hold
02'(
for 3-5 seconds until the last correct code screen
appears.
If you have already used the console, you may see the tamper time screen
instead. If so press
02'(
once to display the last correct code screen.
Figure 1: Last Correct Code Screen
&RQQHFW WKH &RQVROH
With the ignition off, connect the adapter cable to the console cable.
! It is easiest to make the connection by first holding the adapter cable by the
connector housing and holding the console cable by the cable itself next to
the sliding connector housing.
Indicates Unit Running on Battery Power
07395.043 DR GD Inst Rev D Body D146.fm Page 15 Monday, December 1, 2003 12:02 PM