DAVIS DriveRight 600E GD/HD Installation Guide (8126GD, 8126HD) - Manual (Page 23)

7LJKWHQ 8VLQJ WKH 7HQVLRQ 7RRO
The Tension Tool, Æ '(% , operates like a screw-driver and is best used for
single installations.
Trim the stainless steel cable tie using cutters or tin snips so that 2” remains
protruding from the clasp.
! Insert the end of the stainless steel cable tie into the slot at the end of the
tightening tool. Grip the tool by the handle and hold the magnet in place.
Slowly twist the tool to further tighten the cable tie. Rotate the tool so that the
tool tip goes down toward the clasp and under the remaining tie.
" When the desired amount of tension has been reached and the magnet is
secure, slide the tool out of the center of the coil. Flatten the rolled coil
against the shaft.
7LJKWHQ 8VLQJ WKH 'HOX[H 7HQVLRQ 7RRO
The Deluxe Tension Tool, Æ' ($ , incorporates a ratchet mechanism for extra
efficiency. This tool should be used if you are performing multiple installations.
Slide the Deluxe Tension Tool over
the stainless steel cable tie as
shown. Squeeze the handle to apply
tension.
! If the handle is all the way closed
and more tension is needed, release
the handle and slide the tool towards
the clasp.
" Repeat T‡rƒÃ! until the desired
tension has been reached.
# To cut off the end of the cable tie,
hold tension in the tool and twist the
tool either clockwise or
counterclockwise.
Cross Section of
Cable Tie After
Tensioning
Screwdriver-Type Tightening Tool
Deluxe Tension Tool
07395.043 DR GD Inst Rev D Body D146.fm Page 21 Monday, December 1, 2003 12:02 PM