DAVIS Solar Power Kit for Wireless Stations - Manual (Page 5)

Installation for EZ-Mount and Wireless Stations Page 5
I NSTALLATION FOR EZ-M OUNT AND W IRELESS S TATIONS
To transform an EZ-Mount or Wireless station, follow these steps:
1. Unscrew and open the doors on your station field case and solar power kit shelter
with a flat head screwdriver.
2. Remove both doors by slipping them free of their hinges, as shown below.
Angle the door at about a 45 degree angle as shown. Then press firmly and
evenly to push the hinge pins from their cradles.
Note: You may have to use
quite a bit of pressure.
3. Attach the solar power kit door to the field case, as shown below.
Again, positioning the door at a 45 degree angle from the base, squeeze the
door’s cradles around the base’s pins by pressing in hard with your thumbs
and holding the base still with your fingers.
4. If the transmitter is not yet installed, see steps 2-4 on page 3 to install the transmit-
ter in the field case. Once the transmitter is installed, refer to “Powering the Trans-
mitter” on page 6.